CROSS-SECTIONAL AREA OF THE BELT CONVEYOR WITH A THREE-IDLER SET

Authors

  • Leopold Hrabovský

Keywords:

cross-sectional area, belt conveyor, three roll troughed idler set

Abstract

This contribution describes a determination of maximum height of the cap of crosssectional area of the belt conveyor with one-idler set on the basis of known value of useable conveyor belt width. At the same time is determined the biggest crosssectional area of belt conveyor with three-idler set assuming that the values of surcharge angle, conveyor belt width, troughing angle and length dimensions of idlers are known as well.

References

Downloads

Published

2011-07-15

Issue

Vol. 6 No. 2 (2011)

Section

Articles

License

Copyright (c) 2020 Leopold Hrabovský

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

CROSS-SECTIONAL AREA OF THE BELT CONVEYOR WITH A THREE-IDLER SET. (2011). Perner’s Contacts, 6(2), 62-67. https://pernerscontacts.upce.cz/index.php/perner/article/view/828

Similar Articles

1-10 of 185

You may also start an advanced similarity search for this article.

Most read articles by the same author(s)

1 2 > >>