ON THE PROBLEM OF HEIGHT ADJUSTMENT OF THE ACTIVELY CONTROLLED DRIVER‘S SEAT VIBRATION ISOLATION STAND
Klíčová slova:
vibration isolation stand, height adjustment, conducting mechanism, pneumatic springAbstrakt
Every driver’s seat vibration isolation stand is supplied with height adjustment. In
the case of a standard seat vibration isolation stand (passively suspended), such
adjustment is realized by the position mechanical controller. Any change in seat
height results also in the change of the position of the working point of the
pneumatic spring and the reduced mass or reduced inertia moment of the
conducting mechanism are changed as well. This further results in the change of its
natural frequency, transmissibility characteristics etc. These dependencies are
analysed in the paper using an actively controlled driver’s seat vibration isolation
stand with scissor mechanism.
Stažení
Reference
Proceedings of National Conference Engineering Mechanics ’95. Praha: ITAM CAS,
1995.
(2) ŠKLÍBA, J.; LOUDOVÁ, J. On a Next Possibility of the Accuracy of a Driver Seat
Model. In Proceedings of National Conference Engineering Mechanics 2000. Praha:
ITAM CAS, 2000.
(3) APETAUR, M.; BUCHTA, J.; JANEČEK, B.; KUPKA, L.; ŠKLÍBA, J. Actively
Controlled Air-suspended Driver’s Seat – From Laboratory to Tatra Proving Ground.
Perner’s Contacts, 2010, Volume 5, No. IV, p. 7–19. ISSN: 1801-674X.
(4) KUPKA, L. Vývoj aktivně řízené sedačky řidiče. In Sborník příspěvků konference
Dopravní systémy 2009. Pardubice: Institut Jana Pernera, o.p.s., 2009, p. 227–239, ISBN
978-80-86530-63-5.
(5) BARBORA, J.; BUCHTA, J.; JANEČEK, B.; LUFINKA, A.; MAREK, M.; ŠKLÍBA, J.;
APETAUR, M.; KUPKA, L. Research of Actively Controlled Air-suspended Seat for
Vehicles. JVE Journal of Vibroengineering, 9, 2009, Volume 11, Issue 3, Publication 476,
p. 421 – 433, ISSN 1392-8716.
(6) KUPKA, L.; JANEČEK, B.; ŠKLÍBA, J. Laboratory Verification of the Active Vibration
Isolation of the Driver Seat. Recent Advances in Mechatronics. Berlin – Heidelberg –
New York: Springer, 2007, p. 453–457, ISBN 978-3-540-73955-5.
(7) KUPKA, L.: Nelineární model vibroizolačního podstavce sedadla řidiče s nůžkovým
vodicím mechanismem a jeho linearizace. Perner’s Contacts, 2011, Volume 6, No. IV, p.
188–204. ISSN: 1801-674X.
(8) KREJČÍŘ, O. Pneumatická vibroizolace. [Dissertation thesis.] Liberec: VŠST, 1986.
(9) KUPKA, L.: Active Vibration Isolation System of Driver Seat. [Dissertation thesis.]
Liberec, 2008. Technical University of Liberec. Faculty of Mechatronics, Informatics and
Interdisciplinary Studies.
Stahování
Publikováno
Jak citovat
Číslo
Sekce
Licence
Copyright (c) 2020 Libor Kupka
Tato práce je licencována pod Mezinárodní licencí Creative Commons Attribution 4.0 .
